Page 2 of 2
Re: Forum colours
Posted: Sat Jun 12, 2010 10:40 am
by Jeremy Bernstein
emullins wrote:I would like to request adding proFormell style to the board.
I have several that I discovered I like when experimenting with setting up my own board. But I think this is one I'd like to choose here. Thanks.
proFormell installed. Logo looks bad, though. I'll have to make a "dark" version.
Re: Forum colours
Posted: Sat Jun 12, 2010 10:45 am
by Uly
Jeremy, ask me if you need some logos for the board themes.
Re: Forum colours
Posted: Sat Jun 12, 2010 10:46 am
by Jeremy Bernstein
Ovyron wrote:Jeremy, ask me if you need some logos for the board themes.
Sure. I'm not a graphics person, so I'd be thrilled to get some logo donations. I like the image, though.
Re: Forum colours
Posted: Sat Jun 12, 2010 10:47 am
by Uly
I'm puzzled by the current logo, what does it represent?
Re: Forum colours
Posted: Sat Jun 12, 2010 10:49 am
by Jeremy Bernstein
Ovyron wrote:I'm puzzled by the current logo, what does it represent?
It's part of some carpentry instructions I found for building chess pieces. I believe that it's an unfinished bishop being held in a vice.

Re: Forum colours
Posted: Sat Jun 12, 2010 10:52 am
by Uly
I see! I can make a logo under that concept
By the way, I requested the GuildWarsAlliance theme at bottom of page 1.
Re: Forum colours
Posted: Sat Jun 12, 2010 2:05 pm
by Jeremy Bernstein
Ovyron wrote:I see! I can make a logo under that concept
By the way, I requested the GuildWarsAlliance theme at bottom of page 1.
installed!
Re: Forum colours
Posted: Sat Jun 12, 2010 2:47 pm
by DaveD
Jeremy Bernstein wrote:Ovyron wrote:I'm puzzled by the current logo, what does it represent?
It's part of some carpentry instructions I found for building chess pieces. I believe that it's an unfinished bishop being held in a vice.

Actually it's not a vice, but a wood turning lathe. In my younger days, wood turning was a big hobby of mine. And i can say that the setup depicted in this logo is a recipe for disaster, since the turning is off-center, and is not attached to a faceplate at the headstock end.
